|
|
| |
| Paint |
|
 |
Energy Saver Acrylic Urethane Solvent Based |
|
|
|
|
|
|
- General Information
This paint based on specially designed acrylic urethane resin and ceramic
pigment. It is suitable for walls and roofs composed of concrete, mortar,
slate, metals. When this adiabatic functional paint applied on the roof or
wall, the coated surface reflects solar heat and excludes heat conduction.
Thus, it's excellent adiabatic effect helps to save energy for heating as
well as cooling. Ot os widely used for both newbuilding and maintenance coating.
- Suitable Use
- Various kinds of Walls(concrete, mortar, plaster etc)
- Roof of factory, warehouse and houses etc.
- Internal and external wall of cooling warehouse
- Storage tanks for grains and petro chemical products.
- Other structures or places that need the heat conduction.
- Specification
- Type : Acrylic Urethane Non-yellowing type / two-pack
- Drying Times(H:Hour)
Temperature |
5°C |
20°C |
30°C |
Set to Touch |
1H |
1/2H |
1/3H |
Dry Hard |
8H |
5H |
4H |
For Over coat(Min) |
12H |
8H |
6H |
Pot Life |
6H |
5H |
3H |
- Consistency : Ready for use
- Thinner : DR-700(Max.10% at 1st coating, max. 5% at 2nd coating)
- Specific Gravity : Appr.0.7
- Theoretical Coverage : 1.24m2/L(DFT : 500 µm)
- Mixing ratio(bt Wt) : Base : Hardener=4:1
- Shade : White
- Texture : Flat
- Heat conduction : 0.064Kcal/m.h.°C
- Features
- Excellent adiabatic effect
- Low heat conduction
- Protect dewy
- Water proofing effect
- Increasing heating, cooling effect
- Direction for use
- Surface Preparation
-Eliminate oil, water, grit, dirt, marked paint and any foreign matters.
- Preparation of Paint
-Stir to be mixed uniformly
-Avoid excessive thinning
- Application
-Can be applied by brush, roller, Airless Spray
- Other Cautions
- Take care of adequate ventilation, avoid and kinds of fire during and
after application.
- Don't store or ship the paint at temperatures less than 5°C(41°F)
nor above 35°C(95°F)
- Surface to be painted shall be prepared an instrument measered moisture
content not exceeding 8% and less than 9pH.
- Will not form a homogeneous film below 5°C(41°F) or at humidities greater
than 85% R.H
- Close lids after each use and store in the shade.
|
|
|
|
| |
|
|
|
Related Keywords:
Bookmark / Share this page